#119502 - 03/24/08 06:13 PM
surging....*UPDATE*
|
Member
|
Registered: 03/24/08
Posts: 73
Loc: Council Bluffs, IA
|
|
i have a issue, when i drive on the interstate about 60ish, 2000 rpms my car will surge about 100-200 rpms when im applying light throttle, like when i go to speed up a little or going up a slight hill. this was a similiar problem when my cps went bad. i have cleaned my mass air sensor and that fixes the problem for a day then its back again. any suggestons would greatly be appreciated.
_________________________
ZZP 3" catless downpipe, ZZP 1.0 PCM, ZZP shift kit, NGK plugs, 180 thermostat, HAI, 3" exhaust into 2.5" y pipe with magnaflow knockoff mufflers, throttlebody spacer, volt. booster, alt. rewire, HIDS,PLOG, ST struts and springs, poly upper mounts
|
Top
|
|
|
|
#119503 - 03/24/08 06:30 PM
Re: surging....*UPDATE*
|
Member
|
Registered: 04/13/06
Posts: 6709
|
|
Any codes? Fuel filter change? I would go towards cat but I see you have a zzp downpipe. What is the last time you checked plugs, wires, and tune up things? Clean the IAC sensor at all?
_________________________
2002
|
Top
|
|
|
|
#119504 - 03/24/08 06:36 PM
Re: surging....*UPDATE*
|
Member
|
Registered: 04/18/05
Posts: 8901
Loc: Bradenton, FL
|
|
Could be the cat
_________________________
Corey Smith
|
Top
|
|
|
|
#119505 - 03/24/08 06:57 PM
Re: surging....*UPDATE*
|
Member
|
Registered: 03/24/08
Posts: 73
Loc: Council Bluffs, IA
|
|
i put the ngk's in about 5000 miles ago. wires still look to be in good shape. also did thermostat and fuel filter same time. theres no codes and i have a catless dp. im gonna run out and clean the iac and see how it goes.
_________________________
ZZP 3" catless downpipe, ZZP 1.0 PCM, ZZP shift kit, NGK plugs, 180 thermostat, HAI, 3" exhaust into 2.5" y pipe with magnaflow knockoff mufflers, throttlebody spacer, volt. booster, alt. rewire, HIDS,PLOG, ST struts and springs, poly upper mounts
|
Top
|
|
|
|
#119506 - 03/24/08 09:30 PM
Re: surging....*UPDATE*
|
Member
|
Registered: 01/01/08
Posts: 3900
Loc: Ontario, Canada
|
|
if cleaning the MAF works for a day then try replacing it with a new one...
|
Top
|
|
|
|
#119507 - 03/25/08 06:25 AM
Re: surging....*UPDATE*
|
Member
|
Registered: 03/24/08
Posts: 73
Loc: Council Bluffs, IA
|
|
thats what i figured but i wanted to make sure there wasnt something i was missing. thanks for all the input.
_________________________
ZZP 3" catless downpipe, ZZP 1.0 PCM, ZZP shift kit, NGK plugs, 180 thermostat, HAI, 3" exhaust into 2.5" y pipe with magnaflow knockoff mufflers, throttlebody spacer, volt. booster, alt. rewire, HIDS,PLOG, ST struts and springs, poly upper mounts
|
Top
|
|
|
|
#119508 - 03/25/08 07:11 AM
Re: surging....*UPDATE*
|
Member
|
Registered: 01/08/07
Posts: 6026
Loc: Des Moines ,Iowa
|
|
hey i see your from council bluffs thats about 1hr30min from my hometown. good to see another iowa guy on the site
|
Top
|
|
|
|
#119509 - 03/25/08 05:56 PM
Re: surging....*UPDATE*
|
Member
|
Registered: 03/24/08
Posts: 73
Loc: Council Bluffs, IA
|
|
ya and i also think im the only one from council bluffs with a modded gp....
_________________________
ZZP 3" catless downpipe, ZZP 1.0 PCM, ZZP shift kit, NGK plugs, 180 thermostat, HAI, 3" exhaust into 2.5" y pipe with magnaflow knockoff mufflers, throttlebody spacer, volt. booster, alt. rewire, HIDS,PLOG, ST struts and springs, poly upper mounts
|
Top
|
|
|
|
#119510 - 03/25/08 06:30 PM
Re: surging....*UPDATE*
|
Member
|
Registered: 03/07/05
Posts: 5158
Loc: Southern KY
|
|
It's a TCC issue most likely. It isn't disengaging to allow rpms to rise. Next time it happens, keep on the throttle and lightly touch the brake enough to make the brake light come on. I bet it will disengage the TCC and the surging will stop.
_________________________
'13 Mustang 3.7V6 - MT82 '00 GP SE (L67 Swap, XP, Headers, 3.25") '98 GTP, '01 Bonne
|
Top
|
|
|
|
#119511 - 03/25/08 07:09 PM
Re: surging....*UPDATE*
|
Member
|
Registered: 03/24/08
Posts: 73
Loc: Council Bluffs, IA
|
|
i will give that a try rook on my way to work tomorrow and ill keep ya posted.
_________________________
ZZP 3" catless downpipe, ZZP 1.0 PCM, ZZP shift kit, NGK plugs, 180 thermostat, HAI, 3" exhaust into 2.5" y pipe with magnaflow knockoff mufflers, throttlebody spacer, volt. booster, alt. rewire, HIDS,PLOG, ST struts and springs, poly upper mounts
|
Top
|
|
|
|
#119512 - 03/27/08 05:21 PM
Re: surging....*UPDATE*
|
Member
|
Registered: 03/24/08
Posts: 73
Loc: Council Bluffs, IA
|
|
problem fixed for now. Cleaned IAC which was pretty carboned up and no more surging and idles alot smoother thanks 20gtp02 and everyone with their inputs. Greatly appreciated!
_________________________
ZZP 3" catless downpipe, ZZP 1.0 PCM, ZZP shift kit, NGK plugs, 180 thermostat, HAI, 3" exhaust into 2.5" y pipe with magnaflow knockoff mufflers, throttlebody spacer, volt. booster, alt. rewire, HIDS,PLOG, ST struts and springs, poly upper mounts
|
Top
|
|
|
|
#119513 - 03/27/08 06:30 PM
Re: surging....*UPDATE*
|
Member
|
Registered: 04/13/06
Posts: 6709
|
|
Sweettt!
_________________________
2002
|
Top
|
|
|
|
|
|