so i hated my old intake so i decided to make a new one, here are are some pictures, i used 20 ga sheet steel to make it, i just grabed some paint i had layen around i am going to repaint it next weekend, and i will be making a lid for it tomarow but let me know what you think

btw i have to retrim it so i can fit my diag brace back down

I was thinking same thing about brace. It looks too high that will not work for brace. Look good. Good job.

That's a big hole for the intake line.

but the coupler covers most of it up yeah im just going to trim it tomarow for the diag brace

dangg, wanna make me one ?

Thats pretty cool, Even though my intake might not be the same dimensions, I could buy the tubing that Boosten has ?

only thing is i would need an older bodystyle to make/match it to, i did this all by guessing basicly i started with a few cardbord boxes, i got a general shape, cut and fit from there

Well.... Idk, Would be cool if you figured it out, Or i could try to figure it out too

This looks like a real custom job, would be somewhat hard to replicate I think unless you are good at being crafty and visualizing you may struggle at this.

That's what I was thinking too. I like how you have the PCM mounted, looks clean.