Posted by: UMfan
Large photos of my intake (56k warning) - 04/21/06 06:44 PM
I apologize for the large photos, but if I resized them, I'd lose the detail I needed.
So for this one, I noticed the tubing is pulling away from the TB at the top. I tried to tighten the clamp, but that only seems to make the gap worse. I think the weight of the cone is pulling the tubing off the TB. Is there a better fix? I am thinking either CAI box to support the cone, or cut off that 1/2 inch of tubing to the left of the clamp, and clamp as close to the TB as possible. Just wondering if anyone else has this issue?
TB closeup
These are just two photos of the open cone and how I located my PCM tray. I was too lazy to remove the cone for a good photo, but I'm hoping that it's good enough that people can use it as a reference to how to locate a GM PCM tray (the angle was kind of tricky for me).
Cone
PCM tray
So for this one, I noticed the tubing is pulling away from the TB at the top. I tried to tighten the clamp, but that only seems to make the gap worse. I think the weight of the cone is pulling the tubing off the TB. Is there a better fix? I am thinking either CAI box to support the cone, or cut off that 1/2 inch of tubing to the left of the clamp, and clamp as close to the TB as possible. Just wondering if anyone else has this issue?
TB closeup
These are just two photos of the open cone and how I located my PCM tray. I was too lazy to remove the cone for a good photo, but I'm hoping that it's good enough that people can use it as a reference to how to locate a GM PCM tray (the angle was kind of tricky for me).
Cone
PCM tray