well just replaced the battery and still doing the same thing. havent tried to roll it backwards but its making a hissing sound after u try to start it im thinking maybe a bad pcm...

after work tonight im gonna try and capture the audio and also the sound of the hissing sound right after trying to turn it over. oh and im also getting an ses light now too

what's the code?

dont have a scanner!!!!!

autozone does them for free i think.

no way i can get the car there...

oh right lmao.

You need to check fuel and spark.

Walmart has OBD-II scanners for like $20, I don't know how good they are but it's worth a try.

I don't know as much as the other guys about this stuff but could the car not be getting fuel and that hissing sound be a leak somewhere in the fuel system?

i checked for fuel today, i disconnected the line and turned the key fuel came out... so thats a plus im thinking of replacing the starter its only 25 from zz

Just get one from your local parts store. I don't know how much more expensive it will be but you'll get it a lot faster.

did you check for spark?

well i disconnected the 6th wire from the coil pack and it sounded the same when i tried to start it...

Does the motor spin? If so the starter is a non issue.

idk if this will work but give it a try, its zzp's security re-learn-


1. disconnect battery

2. Install new computer

3. Reconnect battery

4. put emergency brake on to disable daytime running lights

5. make sure all doors trunk and hood are closed leave driver window down and reach in threw window

6. try to start. If it doesn't start, leave the key in the on position for 10 min on 97-03 cars and 15 min for 04 and newer cars. The security light should turn off after this amount of time.

7. turn off ignition for 3 seconds

8. Try and start the car. It probably won't start. Repeat step 5 two more times.

9. If this doesn't work disconnect battery for 5 seconds and then try and start the car.

Notes: If your car starts at any time and stays running, you are done. If your car starts and dies, try step 9. If it dies after 2 seconds after you have done these steps, you either have a bad FP resistor or the security setting in your PCM is wrong and it will need an update. Security relearn procedure will not work with the valet key!