look nasty

Do you think I should get everything to replaced because it is over 100K miles car?

that's up to you... if i had the money i'd replace it all plus yours is a "show" car...

Thank Chico. I didn't see your post. I think it is good enough for me.

Okay for now....

GM part 12498617

Cars not orginally equipped with dual exhaust will need the dual exhaust conversion kit 12498653 (sold seperately) Get this one too. I believe they are for left side install too.

and this one

http://www.performancepeddler.com/detail.asp?PRODUCT_ID=MAG23433

Is I miss anything else? Will it not hurt my mpg? lol

The cat back won't effect your MPG the downpipe might if you have a hard time keeping out of the happy pedal. If you drive it like a sane person you may see an increase in mpg.

Ok that's great. Do you think I should let exhaust local shop do that because I never done that? I willing let pro do that for safe if I screw up.

That depends on whether your comfortable doing this type of work,bolting the new system is a piece if cake but removing the old rusty system can be a PIA ,it should'nt be too expensive for a muffler shop to R&R your system.Chico(Pops)

ok thank you. Is o2 sensor on this part or it is located somewhere?

It's in the Ubend just aft of the cat just before the bolted connection.

U bend is from http://www.performancepeddler.com/detail.asp?PRODUCT_ID=MAG23433 ???

Sorry, I'm not very good for car part names. Believe me. I'm learning and everything for mod stuff is new to me like this exhaust lol

There should be a hole with threads called a "bung" on the aft side of the catalytic converter.

Are you looking for a 3" down pipe or just stock parts?

maybe this picture will help you what I'm talking about.

Left side because I have right single exhaust.

Whole exhaust system

Catalytic Converter-Direct Fit>Direct Fit High Flow Stainless Steel Catalytic Converter (for my SE engine)


I don't think I need u-delete because I don't see any for new parts on above of this pictures?

when you get a downpipe you get rid of the ubend delete... unless you get a shorty but that isn't a shorty

There are no special brackets required to make the rear GT bumper fit on an SE. The only thing I noticed in doing the swap was that the splash guards in the rear wheel wells were slightly off and didn't fit exactly right. They still work though.

I coulda swore there were extra braces. But after looking at mine all there was were L brackets that are part of the bumper cover.

I thought these brackets were separate



This one is