Well... just felt like I should post here because I finished my headers last night. Anyone care to throw some words of moral encouragement my direction?

I installed the S&S headers. Really, the only problem I had was installing the O2 sensor. It came WAY too close to the brake lines so it was pretty difficult to get into place. Other than that, the install wasn't too bad. Everything fit nicely, and I didn't have to bend either the oil or trans dipsticks as they were both fine.

Getting the rear header in was somewhat of a PITA. I had a friend pull the motor forward while I finagled it in. Other than that... pretty simple really. Install time was about 7 hrs working on my own for most of that.