I've replaced the blower motor 2x for water, causing bearing failure (the 3rd isn't in yet). All I can figure is the drain is plugged. Where is the drain located on a 2000GTP & best/easist way to clear it? I couldn't find it from below & decided to have a cold brew instead.Fix it tonite I guess.

i bet the stripping seal under the cowl screen has fallen off. pull the screen up and look under the wiper arm. that strip goes on the edge of the cowl.

my grand prix did the same thing. the easiest and fastest way to fix your problem is to re seal the cowl or the black plactic thing at the bottom of the windwhield. just rum some outdoor clear silicone sealer along the top to the cowl and seal it to the windshield

Just got back from a bus. trip last week, popped the cowl cover off & found the rubber seal beneath the cowl was knocked off & the flap on the far RH side folded into the blower plenum (when the windshield was replaced). Fixed that & did the silicone thing...so far so good. Thanks guys

I had the same problem on mine last winter only I didn't do the silicone thing and haven't had any problems yet. Ohh great now I jinxed myself.