Wheel Hub Replacement - Grand Prix Net

You are not logged in. [Log In] Grand Prix Net » Forums » Older Models » 1997-2003 Grand Prix » Wheel Hub Replacement

Page 3 of 3

Topic Options

Rate This Topic

#122581 - 04/23/07 02:02 PM

Re: Wheel Hub Replacement

Jason2000GTP Offline

Member

Registered: 04/16/07
Posts: 45
Loc: Akron, OH

i think i have the BCA in my passanger side and its quiet.. the one in the drivers side was SKF brand from NAPA. but i swear the Timken, BCA and SKF look all the same.

_________________________
-2000 Grand Prix GTP
-Pace Setter Headers
-Pace Setter 3in Catback with 3in ZZP Res
-3.4in Pulley -DHP PCM - K&N Intake -Poly Mounts -AFC2.0 -KYB GR2 Struts -some other stuff

Top

#122582 - 04/23/07 03:35 PM

Re: Wheel Hub Replacement

Richard Candelario Offline

Member

Registered: 12/15/05
Posts: 5286

With the steering popping, you really should check your ball joints, tie rod ends, and pretty much anything and everything that deals with steering/pivoting. Be sure to include the A-Arm mounts, as well.

_________________________

WizAire CAI w/9" K&N & HV3, 2.5" d/p w/h/f cat, Cobra CB, PowerSlot slots w/Hawk HPS, GR-2s, GMPP handling kit, NextLevel STBs, Pilot Sport A/S Plus tires.

98 L36/MM5
RaC

Top

#122583 - 04/23/07 04:05 PM

Re: Wheel Hub Replacement

Jason2000GTP Offline

Member

Registered: 04/16/07
Posts: 45
Loc: Akron, OH

I replaced the ball joint, innner and outer tie rods, driveshaft, the A-arm mounts seem tight, and they (whole cradle and A-arms) were actaully swapped off a GP with about 34k on it when they swapped my tranny a few months back. also new strut top plates w/bearings. sound never changed after all of those things were swapped. then i did the found out for sure its the hub because i can swap it with the passanger side hub and the sound follows the hub.

how it makes that popping sound is beyond me. its Evil i swear!

Top

Page 3 of 3

Previous Topic

Index

Next Topic

Moderator: AustinGTP, Chew, HercMan(Rob), Marc Harbison, Redshift