Well, just got them tonight so I put them in, don't have my HID kit yet so I dont have any light pics or halo pics BUT I will have it all done as soon as I get the HIDs and will post some up them.

Sorry for the bad quality but I only have my 2 MP phone.

Cool.

Looks good! Just wish you could drop that license plate. So you get in on the group buy?
I figure I could get that with the HID kit and sell my headlights, and it'll only cost $400!
LOL

What grills are those?

That looks better than i thought it would. Nice job!

Well I ordered my H1 hids earlier this week so I should have them Monday (hopefully tomorrow but probobly not) so I will get pics up of that. Also going to wire my fog halos and headlight halos to a switch inside, will get pics of that as well, should look good.

The grills are XXL flat from Custom Car Grills.

Yeah unfortunately here in Ontario we have to have a plate on the front as well.

Dang it, those are the ones I almost got, and went with xtremes, dang it!

Looks great though!

wow those would look great with a custom hood made by me !!!

Looks good with the grills, get a hood with the grill inserts same color and you will have one mean gp there.

They look TOUGH! I really like!

Is it me or did they raise those prices from 300 dollars to suddenly around 400 dollars? Jeesh for projectors too, ill wait till that comes down a bit lol.

What kind of quality are they? Do you think they will get moisture in them like most headlights for our cars?

they look to be high quality, better than OEM I think, the lens cover is thicker than that on the OEM headlights. Its raining out right now and is supposed to for the next few days so we will see how they hold up to moisture.

i seen over at club gp some do have condensation... :rolleyes:

They look sexy no doubt, but for $400 It just isnt a reasonable expense unless your wallet is just overflowing with green.

yeah, my driver side has a little moisture in the bottom corner but the other side is fine. It wont affect projector light output and its not really noticeable BUT i guess it is motivation to eventually take the lens off and remove the reflector...


and as a side story, put my rims on yesterday and was over talkin to my neighbours and the one kid was like, f*** ur car is slow, so i was like hmm, might as well test out the nexen's and show him what its got. so me and him and his bro went cruising, when what do ya know, as we were sitting at a stoplight, a later 90's style stang drives around the corner and lights em up. so I pull a U-ee, catch up to him and we both turn on to another street. he drops a gear and we go from about a 25 roll, first kill. Same thing next light, then he drops back a few cars and stays their. Well, the neighbour certainly changed his mind about GPs.

i like 'em... hows the light output on them? a lot better than stock i assume... can you get some pics of the lights when they're on?

yeah, I will post up pics of

1) Halos in heads and fogs (should look mean)
2) HIDS in just projectors
3) HIDS in heads and fogs

anything else?

looks good cant wait for better pics......sucs bout the condensation im workin with the same problem with my left corner of my new black housigns but just found out they need breathability and i sealed a hole it had with silicone and thats y i have water in there

well tonight I will post up pics (I don't have the halos wired yet but i'll just connect them to a power pack or something to see what its like. AND about the condensation, it goes away. It fogs up a bit when its wet and whatnot, but then goes away when its warmer. It's like a breather cap. I love these headlights, much better than stock.

Hey Randy,

Just checking on your condensation problem. I've heard that the condensation is only temporary and only occurs when the car is driving (lights on).. However most cases of condensation that we're used to dealing with occur when the car is just sitting and soaking in the water/fog/wtvr.. We believe this is occuring only from the temp difference when the car is on, and most cases of condensation, correct me if I'm wrong, were temporary and would leave after the temps readjusted from being off.

Just my 2cents anyways.

lmao, totally didn't see the 2nd page of posts.

i want them for my car but how does it work with your single dual beam bulb if u have high and low beams seperate?

it splits them. its all plug and play dont worry.

Did you get any pics yet with the lights in the projectors.

the halos? or HIDs? I have some but don't have them uploaded. I will do that tonight, im at work right now (and I won't use my camera phone this time lol)

lookin very sharp

I ended up getting them for my car too. I'll post pics either once I get them in or after I also get all the exhaust and suspension work done to my car too. I have a little higher quality camera too. :p I think they're going to look great.

I'm thinking about placing an order...

If I got the HID upgrade with them, is it still plug and play, or not?

Yes but using HID's voids the warranty on the lights.

You better hurry up, the group buy over on CGP ends tonight at 6.

True.

I'm not worried about the group buy - it's only $50.

Well finally got my halos wired up. was late so it is kinda dark, they look better at dusk.

nice !!! i like i really want to make my own

$50???....and as the the spyder auto guy yes thats when and why condestation happenes but its not good cause if it happens over and over again it build up and look like crap which is why people are buying new headlights....i have condensation and am tryin how to figure it out not its only in the corners so im not that annoyed but it still will end up looking bad unless i fix it

Very cool man!

Its kinda like an ugly chick.. they look good when its dark

LMAO! Or like having way to many shots.

Just got mine adjusted to remove the body gap, PITA. Started off with a screw driver, moved to a cordless drill after my fingers couldn't work the screwdriver any more. Had to use the full adjustment screw on both sides. We'll see how bad the up/down alignment is when it gets dark out.

Haloes were easy at least, glad I didn't have to use another relay.

WOW looks awsome very impressive!! Maybe my future will have a Halo in it

Nice.

that's impressive. I'm buying a pair now. can they handle HID's?

Yes, voids your 1 yr warranty though. I've yet to see pics with a 4300k HID bulb in these projectors, I'm holding out on upgrading until then so I know if I want 4300k or 6000k. Search clubgp for more discussion on the subject.