I apologize for the large photos, but if I resized them, I'd lose the detail I needed.

So for this one, I noticed the tubing is pulling away from the TB at the top. I tried to tighten the clamp, but that only seems to make the gap worse. I think the weight of the cone is pulling the tubing off the TB. Is there a better fix? I am thinking either CAI box to support the cone, or cut off that 1/2 inch of tubing to the left of the clamp, and clamp as close to the TB as possible. Just wondering if anyone else has this issue?
TB closeup

These are just two photos of the open cone and how I located my PCM tray. I was too lazy to remove the cone for a good photo, but I'm hoping that it's good enough that people can use it as a reference to how to locate a GM PCM tray (the angle was kind of tricky for me).
Cone
PCM tray

a turbo or a csc would do a good job holding the filter better :p

lookin good !

I can't even afford a DP and you want me to change my force induction!?

fine fine....

That's how mine is set up only my PCM is standing up against the coolant bottle. Probably not the best place but until I move that dang bottle. Maybe I'll order the new bottle when I order the resistor.

...and the 3.4 pulley, and the PCM.