Pulley Replacement on 2005

You are not logged in. [Log In] Grand Prix Net » Forums » Older Models » 2004-2008 Grand Prix » Pulley Replacement on 2005

Topic Options

Rate This Topic

#150351 - 05/24/05 03:17 PM

Pulley Replacement on 2005

DeepBlue Offline

Junior Member

Registered: 04/04/05
Posts: 2
Loc: Poughkeepsie, NY

I want to try a 3.4" pulley and have been looking at various pulleys/pullers. Most instructions I've seen are for older GP models. I was wondering if anyone has had experience with this year GP or has a good set of instructions. There doesn't seem to be a nut on the SC shaft, just a plastic cap covering threads inside the shaft. The pulley looks to be pressed on.
Any pointers or tips would be appreciated.
Thanks

_________________________
2005 GTP CompG Mods: CAI, 180 T-stat, 3.4" pulley, TR6ix, trany cooler, Corsa cat-back.

Top

#150352 - 05/25/05 08:25 AM

Re: Pulley Replacement on 2005

AustinGTP Offline

Member

Registered: 05/23/03
Posts: 8078
Loc: Austin, TX

Sounds very similar to the 97-03's.
I don't think there would be much difference.
I think someone was getting the ZZP Gen II puller. You might want to check with ZZP and see how the Gen II puller works versus the Gen I.

_________________________
Bobby

Died 5/1/08, resurrected 5/15/08
ASCD SD hood, 17" Bullitts, Overkill PCM, 3.4" Pulley, NGK TR55IX, K&N 9" cone filter, JimmyC D/P, U-bend removed, Flowmaster 40 series, Hooker big bore tips with resonators, S/B brake lines, drilled/slot rotors, GMPP handling kit, KYB struts, F&R strut supports, HID's, LED's, 2.5" Air Dam, red GTP overlays on custom badges, white rear insert.

Top

Previous Topic

Index

Next Topic

Moderator: AustinGTP, Chew, HercMan(Rob), Marc Harbison, Redshift