2/1 Channel V12 EXPERT Series
Features
2/1 Channel Operation
MOSFET Power Supply
DC-DC PWM Power Supply
No Current Limiting
Double Buffered Pre-Amp Input Circuitry
Discrete Pre-Amp Stage
MOSFET Final Outputs
DC Straight Design
STAR Circuitry
Duo ß Feedback Circuit
Solid Copper Bus Bars
Top Mounted LED Power Indicator
MultiMode™
Adjustable Crossover (HP/LP Capability)
Parametric EQ (1-Band)
Top Panel Adjustment of Parametric EQ ,
Gain and Crossover
4 Volt Straight Input Switch
Input Mode Selector Switch
Low Impedance Switch
Continuously Adjustable Gain Control
Phase Selector
Gold Plated RCA Input Connectors
Extra Large Gold Plated Screw-Down
Power Terminals
Extra Large Gold Plated Screw-Down
Speaker Terminals

SPECS

RMS Power (at 12V, 20Hz—20kHz)
Per channel into 4 ohms .................. 150W x 2 (0.08% THD)
Per channel into 2 ohms ....................... 300W x 2 (0.3% THD)
Bridged 4 ohms ........... 600W x 1 (0.3% THD)


RMS Power (at 14.4V, 20Hz—20kHz)
Per channel into 4 ohms .................... 225W x 2 (0.08% THD)
Per channel into 2 ohms ................... 450W x 2 (0.3% THD)
Bridged 4 ohms .................... 900W x 1 (0.3% THD)


Frequency Response .................. 10Hz—50kHz(+0,-1dB)
Signal to Noise (S/N)....... 110 dBA (referenced to rated power)
Input Sensitivity (for rated power) .......... 200mV to 4V
Slew Factor ............. greater than 5
Input Impedance ......... 10k ohms
Speaker Impedance ........ 4 or 2 ohms(stereo), 4 ohms (bridged)
Dividing Network ..................... 50Hz—200Hz HP/LP(12dB/octave)
Equalizer Center Frequencies .................. 50Hz—200Hz
Q Factor (bandwidth) .................... 10 — 1
Boost and Cut range .................12dB
Power Requirements ........... 11—16V DC (negative ground)


Make me an offer, PM me or email me at techron@ameritech.net before it gets thrown up on ebay in a few days