Anyone install or have instructions on how to install this:

I am confused on the two small red and black wires with the metal male ends.

http://www.vvme.com/hid-headlights/hid-relay-harnesses/relay-harness-for-single-beam-hid-kit

Just found this video, hoping it helps:





http://www.manyadeal.com/page.html?id=27#h5

The red metal go to top of red cover fuse. Remove the nut out and slide this red metal in. If it is too small on this stud then drill it to make a bigger hole like I did on mine. The black metal wire go down by battery tray. You could see stock black wire down there on car frame. That's what I put mine together.

Palsut, those two wires no brainers.
I need to know the small ones, unless I got wrong harness.
I posted pic

Oh I think I have it on my DD car few weeks ago. I didn't do anything on it so I think you will be fine.

Huh?

Never mind I'm too tired from working since 6am. I don't know what is your question for this. This is VERY EASY set up. Picture of how to hook it up tell it all. That's what I did on my both cars.

In second pic, blue and black wires, what socket do they go in?
My two wires are red and black, but they should be same thing.

Make sense to me. I was confused you are talking about red/black wires. On picture that blue and black that I never have it on both cars. I would say you might got a wrong one. Which one you got? 9007 (stock headlight) or H3 (projector)

I have H3 relay on my show car with projector.
I have 9007 relay on my dd car with stock headlight.

H1 with projector.
Sorry. Pic shows blue/black.
Mine is red/black

They should go in to your blue headlight plug on the car. Remove the blue and black wire and insert the red/black pins instead.

Now I have a fresh brain. Now I do remember that. Mine is totally different than what you have. I have a blue plug relay connect on this car. I only lost high beam on pass side so no big deal. HID is brighter than projector high beam anyway.

Ive tried all kinds of things, but I can't get them to turn on.
Anyone with pics?
This blue plug plugs into the blue plug from the vehicle.
Do I unplug these and connect the red/black wires into the vehicle plug?

Wrong relay harness or what?

Found this one, it is setup differently


http://cgi.ebay.com/ebaymotors/HID-Fuse-...=item1c1bb3d6f3

There is a plug where the red/black wires are.
And each ballast plug has its own ground.

I gave up so far, unless someone has more info.
www.vvme.com just sends me that same video I posted.
I've tried that and I still can't get the lights on.
I may try the small wires directly to battery.
I'll post back, if I try it again.