hey randall PM me your address, i got 2 pkgs

Well I understand since you are over 1,000 miles north of hot a$$ florida.

PM you in a sec Andrew, thanks!

We don't get quite as hot as Florida but we do get quite warm (in the 90's) and it's very humid and sticky, it's the uncomfortable heat.

Have some better pics on the actual camera but haven't uploaded yet, these were just taken with the phone.

The case looks the best I think, the candy powder on some of parts didn't get fully coated and you can see the chrome underneath so I'm going to see what I can do to fix that. Other than that they look pretty good. And yes the one pic is upside down, i'll have to fix that later.

wow that looks really nice! SO, what was the total damage to the wallet?

I feel like you, Steve, and I are going to finish out setups at the same time.

When's that? Never? lol. That's how I feel with this. Now I don't think i'll have everything done until middle of June.

I could put it all together now and run non-intercooled and non injected but I want to wait and do everything at once so that it will be a huge noticeable gain from what I have now.

Tim, the case, turbo housing, block off plate, stb and diag braces cost $200.

Exactly. I feel like it's one thing after another.

holy crap i want something like that so bad, it looks AMAZING way to go randall BTW im picken up your pkg this weekend, and the others next monday prehaps shiping next week forsure if i got them

OK, thanks Andrew. No rush, it's going to be a little while now. Though the more stuff I have the more I can work on it and feel like I am actually getting closer.

I'm really looking forward to the rear wheel spacers though I hope it looks good.

Whats with the ultra thick spacer between sc housing an tb?

If mine ever goes turbo, I am coming up with something cool for the left of the housing where the snout use to be, I can't stand the emptiness.

TB Adapter.

That's the only way to run an LS1 TB. Mine is the same thickness.

The adaptor needs to be that thick because the adaptor has to bolt to the case and then the TB needs t bolt to the adaptor. It could be a little bit thinner I guess but not much.

I may even drill and tap it for my meth injection instead of tapping the case.

yes it would be so much more easy drilling and tapping the spacer, i wish i could do meth but i just have to figure a way to set it off at a certin boost like 5PSI of boost or WOT only