I already have a WizAired CAI and 180* stat. I'm going to be adding a ZZP 3" catted dp and 3.4" pulley pretty soon. I was planning on getting an overkill PCM to coincide with my mods, but am also planning on tuning. Should I leave the PCM stock if I'm getting a custom tune? Also, which plugs/wires would suit my application best? What should I gap the plugs at?

If your getting a custom tune there is no need to buy one that is pretuned. You can get a used PCM from Ed if you want to keep a stock tune on hand just incase...

Wires- OEM or ZZPs big honkin wires 10.2mm iirc. Others are just a waste.

Plugs- Autolite 104s Gapped at couldn't tell ya.

x2 with Herc

0.52 is the best gap for the plugs.

Wouldn't that be 0.052? Cause .52 is over 1/2 inch.

woops, that's what I meant, thanks!

104's at .055 would be good for a mild bolt-on setup

i have a spair pcm i can mail you if ur interested