Figured wood is going to work for the ic setup, so I'll make a box for my intake.
Ever since I sold my FWI few months back, my IAT are out the roof.
And reading about Chico's temps, I decided to tackle one tonight.
I am going to fiberglass it, make it pretty.
I used tile board on the bottom for clearance reasons. Filter is so darn large.
Can't decide on a plexi lid or not.
Question: do you think the heat from the bulb, since filter is slammed up near it, will cause the intake temps to be higher? Or is the heat from the bulb minimal?
I wasn't able to get my DLRs turned off.Decided build this tonight, because I went out and bought some resin and bondo for another project!!
I spray painted it black so it shows through the fiberglass. Going to paint it again once fiberglass is on.
Half way fiberglassed it. Needs more and needs to be painted again. Starting to look good. Did a rush job on some fiberglassing. Will clean it up though.
Edit: Added link for all pics, and added and changed pics in this post http://s106.photobucket.com/albums/m252/escapest01/New%20Intake%20design/