Very nice job on that intake box. Did you make a cover or will it be left open?

For the Raised lettering ont he Cover, I used a Paint Pen. Its somethign that I use for my models and thought it would work well there too. And as you can see it did. Its basically a pen filled with paint and a felt tip, you push down the tip on a hard surface and that causes paint to be applied to the tip, then paint away!

As for a cover on the Airbox I will be cutting one out of plexiglas tomorrow. Iam thinking about painting the top rails of hte box gold too. And the Plexiglas Iam goign to use a few screws I think to hold it down, Easily removeable but still held firmly in place.

Hows that paint holding up to the heat?

Paint seems to be doing just fine.