I rented it so I could install the modular hub on my L67 (for rx7 project).

For somebody who's used it.... question!
I follow the instructions, and the little M8 "alignment" threaded piece is supposed to be halfway threaded into the large bolt. I do that and continue with the instructions, and then it looks like when I start cranking the large bolt to remove it, it just smashes this little pin into the center of the pulley... It looks like I would destroy that pin. Is this correct?

there should be a hole in the center shaft of the snout, it sits down in there, to keep the 2 shafts aligned, make sure it sits flush tho because if bolth shafts are not toutching it will snap that little screw and then well you will be screwed it took me a few go arounds to figure out how it all worked but once you start using it it works pretty slick, and dont worry i thought i was going to break something as well

Ah... The supercharger has been replaced on this engine... There is no center hole. I guess thats why.

well there will be a cap its a plastic cap i think try and remove the plastic cap, use a knife or something

Thanks 4drgt. On this one its a funky shaped bolt. Took it out and everything was a cinch.