Topic Options
Rate This Topic
#97006 - 04/27/05 05:59 PM QTEC Exhaust cutout? Anyone else here of this?
bryanp Offline
Member
Registered: 07/11/04
Posts: 363
Loc: Omaha
http://www.clubgp.com/cgi-asp/mods.asp?modid=6

Does this offer any horsepower gains? Does it make problems with not having enough back pressure?

I sort of regret putting an exhaust on my car. Just because the ride quality was incredible without it. laugh

Anyway, I thought it was pretty interesting.

Thanks.
_________________________
'97 Grand Prix GTP Coupe 36k miles
Currently - Wizaired CAI, Intense PCM, 3" r/t downpipe, 3.4" QC pulley, Super 40 Flowmasters, NGK TR55XI spark plugs, Taylor 8mm wires, SLP tips, 180 T-Stat, throttle body spacer, exhaust sheild

http://www.cardomain.com/memberpage/684818
Top
#97007 - 04/27/05 07:00 PM Re: QTEC Exhaust cutout? Anyone else here of this?
AustinGTP Offline
Member
Registered: 05/23/03
Posts: 8078
Loc: Austin, TX
Pressurized engines aren't effected by back pressure, the blower creates it's own pressure.
_________________________
Bobby

Died 5/1/08, resurrected 5/15/08
ASCD SD hood, 17" Bullitts, Overkill PCM, 3.4" Pulley, NGK TR55IX, K&N 9" cone filter, JimmyC D/P, U-bend removed, Flowmaster 40 series, Hooker big bore tips with resonators, S/B brake lines, drilled/slot rotors, GMPP handling kit, KYB struts, F&R strut supports, HID's, LED's, 2.5" Air Dam, red GTP overlays on custom badges, white rear insert.
Top
#97008 - 04/29/05 11:53 PM Re: QTEC Exhaust cutout? Anyone else here of this?
ExpyGator Offline
Member
Registered: 03/10/04
Posts: 77
Loc: Gainesville Florida
I've heard about this particular one having problems , that is if it's the electric one. Just put a manual one in just after the exhaust makes a turn after the resonator. my friend did this on his and he just reaches down near the front of the right rear tire and un-corks it with 2-3 wing nuts.
_________________________
2001 Black 4 door GTP
3.4/K&N/gutted box/drilled 180/wrapped crossover/104's/DHP 1.5/C-ya PCM/TBS/Borla cat back/Tint/Cybers.....PEM's and 3" DP sitting on work bench.
Top