High Temp paint on them and wrapped those with Titanium High Heat Wrap


1st question: Am I heading in the right direction? 350HP is a goal to work towards.

2nd: With this set up will I be able to run a 3.4 or 3.3 Pulley?? knowing I need a scanner regardless..

3rd: **Speed Daddy Headers**, the crosspipe sucks. Tried everything. Won't connect and fit properly at all. Is there any other Speed Daddy Header advice I'll need to know before trying to find someone to cut and weld these to fit?

4th: Has anyone had to cut and weld to make these Headers to fit? And how much will you think that'll cost roughly?

Sorry for the mess of questioned but I should've asked all these questions before I reached in my pocket.. Thanks in advance.