Topic Options
Rate This Topic
#28246 - 08/08/07 06:58 PM Re: Blend door motor for Dual zone climate control
Ryan Offline
Member
Registered: 05/03/02
Posts: 63
Loc: Richmond Hill, GA
Thanks guys, I tried that diagnostic and am getting codes, but none of them are on the list in that link. I will try and get a new actuator and see if that fixws my problem. My ext temp reads correct temp so I don't think that sensor is the problem. Eventually my driver side will cool down but it takes like 25 min. of driving (which sucks when it's 100 degrees out side and the ride home is only 20 minutes.)
_________________________
Ryan Kraus
2000 GTP
K&N cone, 3.4 pulley, U-Bend replacement, tranny cooler
Top



Entire topic
Subject Posted by Posted
Blend door motor for Dual zone climate control Ryan 08/08/07 12:15 PM
Re: Blend door motor for Dual zone climate control Arcxnus 08/08/07 01:08 PM
Re: Blend door motor for Dual zone climate control Chunkee 08/08/07 01:18 PM
Re: Blend door motor for Dual zone climate control Blackarrow98GP 08/08/07 01:32 PM
Re: Blend door motor for Dual zone climate control SlickGTP 08/08/07 02:00 PM
Re: Blend door motor for Dual zone climate control Ryan 08/08/07 06:58 PM
Re: Blend door motor for Dual zone climate control AustinGTP 08/08/07 07:40 PM
Re: Blend door motor for Dual zone climate control johnnywholenote 08/08/07 07:57 PM
Re: Blend door motor for Dual zone climate control SlickGTP 08/08/07 09:47 PM
Re: Blend door motor for Dual zone climate control SlickGTP 08/08/07 09:55 PM
Re: Blend door motor for Dual zone climate control AustinGTP 08/08/07 11:00 PM
Re: Blend door motor for Dual zone climate control SlickGTP 08/09/07 12:44 AM
Re: Blend door motor for Dual zone climate control AustinGTP 08/09/07 08:51 AM
Re: Blend door motor for Dual zone climate control SlickGTP 08/09/07 09:45 AM
Re: Blend door motor for Dual zone climate control AustinGTP 08/09/07 12:45 PM
Re: Blend door motor for Dual zone climate control SlickGTP 08/09/07 01:39 PM
Re: Blend door motor for Dual zone climate control Ryan 08/21/07 10:15 AM